Preparation and installing the A.C.

Ok, so as you can see in figure 1. i have prepared the first red board, the base to fix the ac too, but as this will not be boarded up with gypsum board but will covered with a frame and material stretched to it i need that the ac will be in level fit the cloth so i needed to fix another couple of 5/8 boards on top of the red one, it will also be a nice solid base as you can see in figure 2 and 3, figure 3 also shows the marking of the back plate of the ac so there i could fix the 4 mm rubber mat under the back plate to eliminate any noise as you can see in figure 4 and 5. figure 6 shows the installed A.a.c., figure 7 shows the air gap left above the ac where i will be placing 75 mm rock wool behind too.











Here is the 60 mm hole drilled {which later will be filled air tight with expanding foam}, to pass over the pipes and cables to the compressor which will be fixed on the roof